Skip to main content
NetApp Knowledge Base

How to use the boot_recovery LOADER command for installing ONTAP for initial setup of a system

  1. Last updated
  2. Save as PDF
Views:
3,613
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • AFF A700, AFF A700s, AFF A300, AFF A200 and later models
  • FAS9000, FAS8200, FAS2650, FAS2620 and later models

Description

When setting up a new ONTAP cluster or repurposing an HA Pair some AFF and FAS models support the use of a USB flash drive to perform the boot_recovery procedure to install the desired version of ONTAP.

WARNING

This will remove all configuration from the system.  Only perform for new controller setup or during the repurpose process.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.