Skip to main content
NetApp Knowledge Base

SAN switch rebooted and disabled after reboot

  1. Last updated
  2. Save as PDF
Views:
101
Visibility:
Public
Votes:
0
Category:
fc-series
Specialty:
san
Last Updated:

Applies to

Brocade switch

Issue

  • Fabric Operating System is not loading.
  • The switch went down after multiple reboots with the error:
Raslog Module Initialisation failed rc=-1
fabsys device open: No such device or
address
**************************************************************
*
* Fabric OS has detected frequent switch reboot condition.   
* Following actions can be taken to recover the switch:      
 
*Use supportsave to collect supportsave data.      
*Contact Brocade support team for further assistance.     
**************************************************************
sysmodAttach
open failed: No such device or address
sysconModel: : Illegal seek
can't get Sw Model= 1, default
  • Serial connection was possible to collect supportsave logs

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.