Skip to main content
NetApp Knowledge Base

Veeam backup not deleting cloned volumes after rescan

  1. Last updated
  2. Save as PDF
Views:
1,644
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
hci
Last Updated:

Applies to

  • NetApp Element Plug-In for Veeam Backup & Replication version 10.0
  • Initial scan and automatic rescans

Issue

During (re)scan with NetApp Element Plug-In for Veeam Backup & Replication version 10.0:

  • Veeam initiator reaching hard limit of belonging to 1 volume access group (VAG)
    • NetApp SolidFire Active IQ events: Exceeded maximum number of VolumeAccessGroups per Initiator
      Full output in Additional Information
  • Read-only remnant clone volumes from the failed (re)scan not being removed

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.