Skip to main content
NetApp Knowledge Base

Is there a way to change the warning threshold of HCI volumes used capacity?

  1. Last updated
  2. Save as PDF
Views:
27
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
hci
Last Updated:

Applies to

  • NetApp HCI
  • NetApp ONTAP Select (OTS)

Answer

No, there is no way to change per volume utilization thresholds on HCI clusters

Additional Information

  • Only cluster level thresholds can be changed
  • Status of a volume's used capacity threshold will reach a warning state (yellow) at 80% utilization
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.