Skip to main content
NetApp Knowledge Base

ONTAP Select: Network connectivity Checker quick check fails on new deployment

  1. Last updated
  2. Save as PDF
Views:
299
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
VIRT
Last Updated:

Applies to

  • ONTAP Select
  • Multi-node deployment
  • VMware VSphere

Issue

When deploying a new ONTAP Select Cluster quick network connectivity checker fails with:
 
An error occurred while performing a ping from host (192.168.0.6) to host2 (192.168.0.7) with all links up. Many network configuration issues can cause 
issue. Suggestions:

1. Verify that the host is connected to at least one uplink in the 'up' state.
2. Verify that the sending and receiving uplinks are part of the same VLAN.
3. Verify that the STP setting on the physical switch is correct.
The reccomended STP setting on the switch ports connected to the host host 'Edge/PortFast'
If a cluster has been deployed and subsequently reconfigured outside of ONTAP Select Deploy, run a refresh operation on the cluster, and then try again.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.