Why is "cdp enable" not showing in running-config on cisco switches after applying the RCF?
- Views:
- 898
- Visibility:
- Public
- Votes:
- 0
- Category:
- metrocluster
- Specialty:
- nas
- Last Updated:
- 5/26/2022, 11:11:53 AM
Applies to
- MetroCluster over IP
- Cluster Switches
- Cisco
- Reference configuration file (RCF)
- Cisco Discovery Protocol (CDP)
Answer
- The
cdp enable
setting is only visible in the running-config if it is globally disabled - To verify the CDP setting use the
show cdp neighbors
command instead
site-a-sw2# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device, s - Supports-STP-Dispute
Device-ID Local Intrfce Hldtme Capability Platform Port ID
cbc-mgmt-sw-r01 mgmt0 138 S I WS-C2960-24TT Fas0/22
cluster-a-01 Eth1/3 176 H AFF-A800 e1a
cluster-a-02 Eth1/4 174 H AFF-A800 e1a
Additional Information
For the diffrent version of nexus os use the cisco web site for more documentation on the commands