Skip to main content
NetApp Knowledge Base

MP1 port disabled on ATTO 7600N

Views:
1,138
Visibility:
Public
Votes:
2
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ATTO Fibrebridge 7600N

Issue

Ethernet management port 1 shows disabled when running get ipaddress all during initial bridge configuration.
It can show as disabled before or after assigning an IP address to the port.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.