Skip to main content
NetApp Knowledge Base

METROCLUSTER SWITCHOVER FAILED - negotiated switchover incomplete

Views:
140
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9

Issue

  • After initiating a negotiated switchover (NSO), the operation fails with an error message
Example:
Cluster_A::> metrocluster operation show

       Operation: switchover
           State: successful
      Start Time: 5/24/2023 06:35:38
        End Time: 5/24/2023 06:35:44
          Errors: Failed to execute the switchover operation for the node components. Cluster_A (fatal): Unable to determine the result of the negotiated switchover operation for the remote nodes. Ensure the remote nodes are shut down and then retry the switchover operation with the "-forced-on-disaster true" option.
 
  • The MetroCluster is in an inconsistent state
Example:
Cluster_A::> metrocluster node show
DR                               Configuration  DR
Group Cluster Node               State          Mirroring Mode
----- ------- ------------------ -------------- --------- --------------------
1     Cluster_A
              node_A_1           configured     enabled   negotiated switchover incomplete
              node_A_2           configured     enabled   negotiated switchover incomplete
      Cluster_B
              node_B_1           configured     enabled   negotiated switchover completed
              node_B_2           configured     enabled   negotiated switchover completed

Cluster_A::> metrocluster show

Configuration: IP-fabric

Cluster                        Entry Name             State
------------------------------ ---------------------- ---------------------
Local: Cluster_A
                                 Configuration State   configured
                                                Mode   normal
                                 AUSO Failure Domain   auso-on-cluster-disaster
Remote: Cluster_B
                                 Configuration State   configured
                                                Mode   normal
                                 AUSO Failure Domain   auso-on-cluster-disaster

  • Aggrs switched over, but config not switched over

Example:

Cluster_A::> aggr show
...

Cluster_B Switched Over Aggregates:
Aggregate     Size Available Used% State   #Vols  Nodes            RAID Status
--------- -------- --------- ----- ------- ------ ---------------- ------------
aggr3_node_B_1
           355.5GB   334.2GB    6% online       3 node_A_1         raid_dp,
                                                                   mirrored,
                                                                   normal

 

  • Switchover simulate was successful a matter of seconds/minutes before the NSO operation

Example:

Cluster_A::> met op show
  (metrocluster operation show)
       Operation: switchover-simulate
           State: successful
      Start Time: 5/24/2023 06:35:08
        End Time: 5/24/2023 06:35:24
          Errors: -

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.