Skip to main content
NetApp Knowledge Base

Is ACP (Alternate Control Path) supported in MetroCluster Configurations?

Views:
1,386
Visibility:
Public
Votes:
1
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster
  • Alternate Control Path (ACP)
  • ATTO FibreBridge

Answer

Is ACP supported in MetroCluster Configurations?

ACP support is independent of the use of ATTO FibreBridge usage or direct SAS attached configurations

Out-of-Band ACP
  • Not supported in any MetroCluster configuration
In-Band ACP 
  • Is supported if 
    • IOM12 modules (DS460C) with ONTAP 9.2 and later are used

    • IOM12 modules with ONTAP 9.1 and later are used
  • Interoperability: 
    • If there is a combination of IOM12 and IOM6, In-band ACP should be disabled.
    • In-band ACP is not supported with IOM6 modules and should be disabled.

Additional Information

For more details, see MetroCluster Installation and Configuration guide.

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.