Skip to main content
NetApp Knowledge Base

Disk not partitioned after replacement in MetroCluster IP

  1. Last updated
  2. Save as PDF
Views:
529
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9.5+
  • Advanced Disk Partitioning (ADP)

Issue

After a disk replacement the new drive shows as not partitioned in sysconfig -r: 

RAID Disk    Device         HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
---------    ------         ------------- ---- ---- ---- ----- --------------    --------------
Spare disks for block checksum
spare       e0f.10.1.16    e0f   10  16         0 SSD-NVM   N/A 3662580/937620544 3662830/937684566 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.