Skip to main content
NetApp Knowledge Base

Need to know which service ports in ONTAP are used for inbound and outbound

  1. Last updated
    Jun 25, 2024
  2. Save as PDF
Views:
167
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:
6/25/2024, 12:24:39 PM

Applies to

ONTAP 9

Answer

  • If the requirement is to allow traffic only to the ONTAP from an external Host, the port should be forwarded(opened) with Inbound Setting.
  • If the traffic only needs to move from the ONTAP to an external host it should be Outbound.
  • If the requirement is to exchange traffic to and from the ONTAP it should be bidirectional. In general, if there is no specific condition the ports are always kept bi-directional.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.