Skip to main content
NetApp Knowledge Base

Is it possible to re-learn ARP after switching it to active mode?

  1. Last updated
    Mar 7, 2025
  2. Save as PDF
Views:
96
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:
3/7/2025, 3:40:06 PM

Applies to

  • ONTAP 9.10.1 to 9.15.1
  • Autonomous Ransomware Protection (ARP)

Answer

Yes, it is possible to re-learn Autonomous Ransomware Protection after switching it to active mode, however, previous learning data will be cleared.

Note:  Learning mode is no longer needed on ONTAP 9.16.1 or later versions with FlexVol volumes.

Additional Information

The re-learning steps:

  1.  Disable ARP.
  2.  Enable ARP for learning mode.

Note: When the ARP is disabled, the learning data will be cleared.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.