Skip to main content
NetApp Knowledge Base

TPM doesn't update due to valid NVRAM contents

  1. Last updated
  2. Save as PDF
Views:
268
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS 2720
  • ONTAP 9

Issue

TPM firmware fails to update:
There appears to be valid data in the NVRAM.  You must boot Data ONTAP in order to flush
the NVRAM to disk, and then cleanly shutdown the filer with the halt command.
Skipping TPM firmware update due to pending user data at NVMEM region.
Failed to set BMC LED status: Invalid command.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.