Skip to main content
NetApp Knowledge Base

SP firmware errors when network settings are applied

Views:
21
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:
3/17/2025, 7:29:24 PM

Applies to

  • ONTAP 9
  • FAS9000

Issue

  • EMS shows SP firmware not supported alerts, even though the system is running a valid firmware revision:
node01: sp.firmware.version.unsupported:ALERT]: The SP firmware version is not an official release.
  • EMS shows SP firmware does not support the HW assist feature.
node01 ERROR cf.hwassist.FwUpgrade: HA hw_assist: Partner(node02) SP firmware does not support the hw_assist feature
  • Issue clears without intervention, and no alerts seen again.
  • SP previously had no networking configuration.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.