Skip to main content
NetApp Knowledge Base

Onboard ports set to 100Mbps following motherboard replacement

  1. Last updated
  2. Save as PDF
Views:
84
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS2552
  • ONTAP 9

Issue

  • Following motherboard replacement, ports e0a and e0b speed set to 100Mbs, but should be set to 1Gbps 

    Example: 
    slot 0: Gigabit Ethernet Controller 82580
       e0a MAC Address:    00:a0:98:83:28:85 (auto-100tx-fd-up)
       e0b MAC Address:    00:a0:98:83:28:86 (auto-100tx-fd-up)
       e0M MAC Address:    00:a0:98:83:28:87 (auto-1000t-fd-up)
       e0P MAC Address:    00:a0:98:83:28:88 (auto-1000t-fd-up)
       Device Type:        150E
       Firmware Version:   3.22 0x80000101
  • Manually setting port speed does not resolve issue 
  • Reseating cables does not resolve issue

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.