Skip to main content
NetApp Knowledge Base

How to remove and install the bezel of AFF-C60 system

  1. Last updated
  2. Save as PDF
Views:
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

AFF-C60

Answer

  • Bezel Removal

    • Firmly grasp the Bezel along each end

    • Pull the Bezel straight away from the Chassis to release the Bezel from the Chassis and disconnect the spring-loaded contacts for the Illuminated Logo

      • Be sure to firmly grasp the Bezel until the (4x) ball stud clips disengage from the Chassis

  • Bezel Installation

    • Firmly grasp the Bezel along each end

    • Align the ball stud clips to the (4x) ball studs on the Chassis

    • Firmly push the Bezel onto the (4x) ball studs to secure the Bezel to the Chassis and connect the spring-loaded contacts for the Illuminated Logo

      • The NetApp Logo should illuminate if the system is powered on and the software setting to disable the illuminated NetApp Logo has not been activated

Additional Information

additionalInformation_text

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.