Skip to main content
NetApp Knowledge Base

How to proceed when configuration is not found in IMT with HPE ProLiant DL380 Gen11?

  1. Last updated
    May 12, 2025
  2. Save as PDF
Views:
19
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:
5/12/2025, 7:14:27 AM

Applies to

  • ONTAP 9
  • HPE ProLiant DL380 Gen11
  • VMware ESXi 8.0 U3

Description

  • When configuration does not appear in IMT, it may not be supported.
    • In this scenario you can report this to the IMT team if you think this configuration is supported though not registered.
  • However, in this case, the service protocols running in the Hypervisor are not clear.
    • If the user decides to use NAS (CIFS/SMB, NFS), then there are no hardware requirements. 
    • If the user decides to use SAN (iSCSI/FC), then a supported HBA/CNA card is required. 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.