Skip to main content
NetApp Knowledge Base

Fault LED turns on and off repeatedly

  1. Last updated
  2. Save as PDF
Views:
455
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
HW
Last Updated:

Applies to

  • FAS9000
  • ONTAP 9.x

Issue

P3V3_BATT error event can be found in the following command output.

Example:
cluster::> system controller service-event show
 
Node ID Event Location Event Description
---------------- --- ---------------------------------- ----------------------
node 1 Coin-cell battery on Controller B ipmi P3V_BATT lower non-critical
 
SP node> system service-event show
ID FRU Description Fault Reason
--- ------------------------ ------------------
1 Coin-cell battery on Controller B ipmi P3V_BATT lower non-critical
 
Fault Lights On:
/chassis-1
Controller B
Coin-cell battery on Controller B

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.