Skip to main content
NetApp Knowledge Base

Fail to change BMC IP via LOADER

Views:
41
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • AFF-C800
  • ONTAP 9

Issue

  • Change BMC IP from 10.1.1.3 to 10.1.1.2 via LOADER.

LOADER-A*> sp setup -d=0 -a=10.1.1.2 -n=255.255.255.0 -g=10.1.1.1

  • After changing from LOADER, boot ONTAP into clustershell,however 10 minutes later BMC IP sync back to 10.1.1.3 rather than 10.1.1.1.

::> system service-processor show

Node Type Status Configured Version IP Address
------------- ---- ----------- ------------ --------- -------------------------
node01 BMC online true 10.9P2 10.1.1.3

  • SP-DEBUG-MLOG-TXT.GZ report BMC IP update to 10.1.1.3 during ONTAP boot.

2025-03-17 08:04:51.959 [sp_applications_init] [rlm_mgmt]:  BEGIN - bmc_netconfig_if = 1
2025-03-17 08:04:52.425 [sp_applications_init] [none]: orftp_rcvr_from_rlm get file (/etc/rlm_config_to_filer) success, it took 0 seconds
2025-03-17 08:04:52.425 [sp_applications_init] [rlm_mgmt]: rlmp_parse_stats_file: buf is version 10.9P2
2025-03-17 08:04:52.425 [sp_applications_init] [rlm_mgmt]: rlmp_parse_stats_file: buf is ip 10.1.1.3
2025-03-17 08:04:52.425 [sp_applications_init] [rlm_mgmt]: rlmp_send_config: -- updating config

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.