Skip to main content
NetApp Knowledge Base

Disk show old system ID after disk reassign

  1. Last updated
  2. Save as PDF
Views:
4
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • Advanced Disk Partitioning(ADP)
  • Replacing motherboard in no takeover mode

Issue

  • disk show -v command report both new and original system ID after disk reassignment post motherboard replacement.

*> disk show -v
  DISK       OWNER                    POOL   SERIAL NUMBER         HOME                     DR HOME           
     CHKSUM
------------ -------------            -----  -------------         -------------            -------------     
     --------
0b.00.8P1    node1    Pool0  xxxxxxxxxxxx         node1(old systemID)                  
      Block
0b.00.8P2    node2   Pool0  xxxxxxxxxxxx         node1(new systemID) 

  • Below command used for disk reassignment.

*> disk reassign -s 511111111 -d 511111112 -p 0511111113

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.