Skip to main content
NetApp Knowledge Base

Backplane LED continues to blink even after disk removal

  1. Last updated
  2. Save as PDF
Views:
175
Visibility:
Public
Votes:
0
Category:
disk-drives
Specialty:
hw
Last Updated:

Applies to

  • FAS/AFF Systems
  • ONTAP 9

Issue

  • The storage disk set-led -action blink command is used to turn on blinking for specific disks for identification.
  • The backplane LED keeps blinking amber even after removing the specified disks.
  • Reseating the disks or inserting a new disk into the specific slot does not change anything.
  • The blinking does not stop even after running the storage disk set-led -action command with on, off and resetall.
  • Reseating the IOMs of the affected shelf does not help.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.