Skip to main content
NetApp Knowledge Base

BMC firmware upgrade stuck at 10% and not progressing

  1. Last updated
  2. Save as PDF
Views:
474
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS2720 / FAS2750
  • ONTAP 9
  • Baseboard Management Controller (BMC)

Issue

BMC firmware upgrade from ONTAP is stuck at 10% and not progressing:

::> service-processor image update-progress show
(system service-processor image update-progress show)
                           
Node In progress   Start Time     Percent Done   End Time
------ --------- -------- ------------------- ------- ---------
Node01  yes      4/15/2024 11:52:21  10      -
Node02  no       4/15/2024 11:27:31  0       4/15/2024 11:28:15
2 entries were displayed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.