Skip to main content
NetApp Knowledge Base

ACP showing Additional Connectivity status after ONTAP upgrade

  1. Last updated
  2. Save as PDF
Views:
678
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • Out-of-band ACP

Issue

ACP reports Additional Connectivity on the system after an ONTAP upgrade was performed.
 
Cluster::> storage shelf acp show
Node                Channel          Connectivity
------------------  ---------------  ----------------------
node-01      out-of-band          full-connectivity
node-02      out-of-band          additional-connectivity
 
Cluster::> system node run -node <node name> -command sysconfig -a
System Storage Configuration: Multi-Path HA
System ACP Connectivity: Additional Connectivity
 
Following is seen on the system for some ACP modules:
xx:xx:xx:xx:xx:xx 15 368 1.2.02.12 536977531 0x4 .255.B IOM6 0x20
xx:xx:xx:xx:xx:xx 15 236 1.2.02.12 536977531 0x4 .255.B IOM6 0x20

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.