Skip to main content
NetApp Knowledge Base

CONTAP-543573: Extra whitespace and quotation marks in "Chassis ID" in "system chassis show" output

  1. Last updated
  2. Save as PDF
Views:
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Issue

Extra whitespace and quotation marks are displayed in the "Chassis ID" field of the "system chassis show" CLI command output.
The following is an example of the output:
::> system chassis show
Chassis ID                 Status          List of Nodes
-------------------------- --------------- ----------------------------------
012341234414               ok              node5, node6
012341234029               ok              node3, node4
"0412341234232 "           ok              node8, node9
3 entries were displayed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.