Skip to main content
NetApp Knowledge Base

CONTAP-48039: SP/BMC firmware upgrade is stuck in progress "update-progress show" output

  1. Last updated
  2. Save as PDF
Views:
90
Visibility:
Customer
Votes:
1
Category:
ontap-9
Specialty:
HW
Last Updated:

Issue

  • Service Processor firmware upgrade progress might be stuck  in the output of the system service-processor image update-progress show command during an automatic or manual firmware update. 

::*> system service-processor image update-progress show
In Percent
Node Progress Start Time Done End Time
---------------- -------- ------------------- ------- -------------------
node-01 no - 0 -
node-02 yes - 93 -
2 entries were displayed. * This issue can occur whether the actual firmware update is successful, aborted, or fails.
::> system service-processor show

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.