Skip to main content
NetApp Knowledge Base

CONTAP-391163: BMC Firmware Automatic Update Disconnects an Active System Console Session

  1. Last updated
  2. Save as PDF
Views:
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
HW
Last Updated:

Issue

On certain platforms, a Baseboard Management Controller (BMC) firmware automatic update can start while a system console session through the BMC is active, rather than waiting for the session to end.
If you connect to the BMC through SSH and run {}system console{}, the console session can disconnect when an automatic firmware update begins. This occurs when BMC firmware automatic updates are enabled and a newer firmware image is available.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.