Skip to main content
NetApp Knowledge Base

CONTAP-168983: The “system environment sensors show” command failed after upgrading BMC FW from 11.3P2 to 11.9

Views:
222
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Issue

The “system environment sensors show” command failed with following error after upgrading BMC FW from 11.3P2 to 11.9
Warning: Unable to list entries on node node01. Timeout: Operation "environment_sensors_iterator::next_imp()" took longer than 25 seconds to complete [from mgwd on node "node02" (VSID: -1) to mgwd at xxx.xxx.xx.xxx]
Error: show failed: The Service Processor on node "node02" is not reachable. Check the network configuration, verify that the node is running, verify that the SP is online, verify that api-service is enabled on the SP, and try the command
This issue will be seen in :
1. Platform AFFA800 operating on ONTAP version 9.5P8, with BMC version 10.8 or later.
2. Platforms FAS2750, FAS2720 and AFFA220 operating on ONTAP version 9.5P8, with BMC version 11.9 or later.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.