Skip to main content
NetApp Knowledge Base

Health check commands for NetApp CN1610 and CN1601 switches

Views:
2,317
Visibility:
Public
Votes:
1
Category:
fabric-interconnect-and-management-switches
Specialty:
HW
Last Updated:

Applies to

  • CN1610 Cluster Network Switch
  • CN1601 Cluster Management Switch

Description

  • Health check commands to be collected for troubleshooting NetApp CN1601 and CN1610 ethernet switches.
  • A "show tech-support" will provide all the sections shown below. However, the output is very lengthy and is time-consuming to retrieve, especially from the serial port
  • Individual sections can be retrieved using the CLI commands shown , for example during troubleshooting or for final verification after servicing.

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.