Skip to main content
NetApp Knowledge Base

CN1610 configure TACACS but not working

  1. Last updated
  2. Save as PDF
Views:
110
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
HW
Last Updated:

Applies to

  • CN1610
  • CN1601
  • FASTPATH 1.3.0.3

Issue

  • The customer followed CN1610 Switch Administrator’s Guide page 156 to configure TACACS+, but failed to log in using TACACS+ after the configuration was completed.
  • Check show tech-support log, we found following TACACS+ error message:
 
Feb 10 23:33:48 TWTPCN16N01-1 TACACS[tacacs_task]: tacacs_authen.c(1208) 37467 %% TACACS+: no key configured to encrypt packet for server 10.4.6.50.
Feb 10 23:33:53 TWTPCN16N01-1 TACACS[tacacs_task]: tacacs_control.c(171) 37468 %% TACACS+: connection timeout to server 10.0.6.75.
Feb 10 23:33:53 TWTPCN16N01-1 TACACS[tacacs_task]: tacacs_authen.c(758) 37469 %% TACACS+: authentication error, no server to contact. TACACS+ request needed, but no servers are configured.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.