Skip to main content
NetApp Knowledge Base

Power supply failure on CISCO MDS switch

  1. Last updated
  2. Save as PDF
Views:
704
Visibility:
Public
Votes:
2
Category:
fabric-interconnect-and-management-switches
Specialty:
san
Last Updated:

Applies to

CISCO MDS Switch

Issue

Power supply reported as Fail/Shut on show environment command :

HKSHT1-SW-F11S-1-new# show environment
Power Supply:
Voltage: 12 Volts
-----------------------------------------------------
PS Model Power Power Status
(Watts) (Amp)
-----------------------------------------------------
1 DS-C48S-300AC 300.00 25.00 Ok
2 ------------ 0.00 0.00 Fail/Shut
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.