Skip to main content
NetApp Knowledge Base

Unable to login to SANnav after it enters emergency mode

  1. Last updated
  2. Save as PDF
Views:
81
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • SANnav managemet portal 2.2.1
  • VMware Virtual appliance
  • Centos Linux 7.9

Issue

  • SANnav management portal entered into emergency mode.

emergency mode.png

  • Unable to login to SANnav GUI.
  • After logging into CLI it does not show that SANnav services have started or can be started.
  • No changes made on the network side.
  • After rolling back the Virtual appliance(VA) to the previous restore version the screen still appears to be in emergency mode.
  • There is no IP address assigned to the VA.
  • Unable to monitor or receiving alerting from the Fibre Channel SAN directors

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.