Skip to main content
NetApp Knowledge Base

Brocade switch has no power and does not boot

Views:
612
Visibility:
Public
Votes:
1
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade 6505
  • Brocade 6510

Issue

  • The brocade switch does not power up anymore
  • Configurations with only one PSU: No LEDs are lit up
  • Configurations with more than one PSU: Amber LED blinking on one of the PSUs
  • The power to the brocade switch has been checked and meets the requirements
  • Power cycle by reseating the power cable on the Brocade switch will not mitigate the issue

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.