Skip to main content
NetApp Knowledge Base

Post FOS upgrade E port state changed to G port

  1. Last updated
  2. Save as PDF
Views:
195
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade Fibre Channel switches

Issue

  • After FOS upgrade, port state has changed to generic port

Example:

Before switch firmware upgrade
 
Index Slot Port Address Media  Speed        State    Proto
============================================================
47  47   052f00   id    32G   Online      FC  E-Port  (Trunk port, master is Port 42)
 
 
After the firmware upgrade
Index Port Address  Media Speed   State       Proto
==================================================
47  47   052f00   id    32G   Online      FC  G-Port
 
Tx and Rx looks good before and after upgrade:
RX Power:    -0.7    dBm (848.2uW)
TX Power:    -0.1    dBm (987.5 uW)
 
  • No errors reported on porterrshow and errdump
  • During the exchange link parameters ( ELP )  unable to negotiate exchange between local and remote ports

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.