Skip to main content
NetApp Knowledge Base

SolidFire Node offline with Critical Sensor Error, Volt_PVCCIN_CPU0 - lower critical going low

  1. Last updated
  2. Save as PDF
Views:
574
Visibility:
Public
Votes:
0
Category:
solidfire-chassis
Specialty:
solidfire
Last Updated:

Applies to

  • NetApp H610S
  • NetApp H615C

Issue

  • H610S or H615C node offline
  • BMC/IPMI dashboard and Sensor Event log shows Error
    • [Critical] [Volt_PVCCIN_CPU0] [Voltage] Lower critical - Going Low (Reading: x.xx Volts/ Threshold: x.xx Volts) - Asserted
    • [Warning] [BMC FW Health] [Management Subsystem Health] Management controller unavailable (BMC hardware watchdog timeout reset) - Asserted
    • [Critical] [NM Status] [Management Subsystem Health] Management controller unavailable - Asserted
    • critical sensors, Volt_CPU1_ABC 0.049 Volts lower critical going low.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.