Skip to main content
NetApp Knowledge Base

Volume not on preferred path due to AVT/RDAC failover event

  1. Last updated
  2. Save as PDF
Views:
735
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  •  E-Series
  • SANtricity 11.70.3
  • Linux
  • Auto Volume Transfer (AVT)
  • Redundant Disk Array Controller (RDAC)

Issue

    Volume not on preferred path due to AVT/RDAC failover

Failure Entry 1: NON_PREFERRED_PATH-Recovery Failure Type Code: 10

Failure Entry 2: ALB_INCOMPATIBLE_HOST_DRIVER-Recovery Failure Type Code: 474

  • Linux client fail to run or freeze CLI on multipathing commands:

Multipath -ll
multipathd show paths
/etc/multipath.conf

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.