Skip to main content
NetApp Knowledge Base

SANtricity Controller Database Error after reboot from upgrade or manual reset

  1. Last updated
  2. Save as PDF
Views:
510
Visibility:
Public
Votes:
0
Category:
e-series-santricity-os-controller-software
Specialty:
esg
Last Updated:

Applies to

  • SANtricity OS 11.70.x
  • Disk Pools with 256TiB or larger volumes, and history of configuration changes (volume creation, expansion)

Issue

  • Controllers are in lockdown with error code OE Lt and OE LF on 7-segment display
  • SANtricity System Manager reports the following:
Alternate Controller Database Error
Lockdown code: 0ELt
The storage array has detected an error with the alternate controller's database and has locked down to preserve the data on the storage array. Contact your Technical Support Engineer for assistance correcting this problem.
  • Following (or similar) is seen during start-of-day in serial console:

(tRAID): ERROR: CrushStripe DeSerialization - Same stripe registered multiple times! Volume 0 SegmentID 0 StripeIndex 100586

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.