Skip to main content
NetApp Knowledge Base

SMCLI Commands Fail When Running show storageArray summary

  1. Last updated
  2. Save as PDF
Views:
13
Visibility:
Public
Votes:
0
Category:
e-series-santricity-management-software
Specialty:
esg
Last Updated:

Applies to

  • NetApp E-Series 11.50
  • NetApp E-Series SMcli

Issue

SMcli Commands ran on newer Firmware (11.60 or above) fail while on an older version of the SMCLI Client 
/opt/SMgr/client/SMcli 10.13.32.43 -c " show storageArray summary;"
Performing syntax check...
Syntax check complete.
Executing script...

Unable to execute the command at line 1 because an internal error occurred.

Please retry the operation.
Error 10029 - An internal software error occurred.  Retry the operation.  If this message persists, contact your Technical Support Representative.
The command at line 1 that caused the error is:

show storageArray summary;

Script execution halted due to error.
SMcli failed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.