Skip to main content
NetApp Knowledge Base

Data could not be loaded from storage

  1. Last updated
  2. Save as PDF
Views:
114
Visibility:
Public
Votes:
0
Category:
e-series-santricity-storage-manager
Specialty:
esg
Last Updated:

Applies to

  • E-series
  • NetApp SANtricity System Manager

Issue

SANtricity system manager pops up below errors:
 
Your cient browser cannot communicate with the storage array to complete the operation. Possible causes include network issues, inability to communicate with the controller, or loss of power to the storage array. Check these causes and then retry the operation.
 
Data could not be loaded from the storage anay. One possible cause is the object on which you were performing the operation no longer exists. Oiher possible causes include network issues.
inability to communicate with the controller, or loss of power to the storage array.Check these causes and then retry the operation.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.