Skip to main content
NetApp Knowledge Base

SnapCenter verification sub-job hang with state Running

not set
Last Updated:

Applies to

  • SnapCenter Plug-in for SQL (SCSQL)
  • SnapCenter Servef (SC)


  • After backup job finishes successfully, verification sub-job shows state "Running"
  • Trying to stop the verificaiton sub-job will casue the error "Cannot cancel the job. Reason: Cancellation of job xxxx, of type Backup and status Completed with verification pending is not supported"



Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device


  • Was this article helpful?