Skip to main content
NetApp Knowledge Base

SMBR fails to authenticate

Views:
529
Visibility:
Public
Votes:
0
Category:
single-mailbox-recovery-smbr
Specialty:
snapx
Last Updated:

Applies to

  • Single Mailbox recovery (SMBR) 8.3
  • SnapCenter Server 4.3 and later

Issue

The SnapCenter authentication wizard reports that SMBR fails to authenticate to the remote Exchange Server:

Authentication failed: If trying to connect to a remote Exchange Server please provide a valid Exchange Server name or IP address when authenticating

SMBRauth.png

The following warning may be present in the Application Event Logs on the SMBR server:

Level: Warning
Event: 300, 
Source: PowerShell(PowerShell)

Provider Health: WinRM cannot process the configuration request.  The hostname pattern "*" is invalid.  Hostname patterns must contain one or more patterns.  A pattern can contain at most on wildcard ("*").  The special pattern "<local>" can be used to indicate all hostnames that do not have a ".".  To trust all hosts use "*" as the only pattern.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device