Skip to main content
NetApp Knowledge Base

Why is a SysLog Test Message Marked As Successful When Not Received

  1. Last updated
    Apr 10, 2024
  2. Save as PDF
Views:
72
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:
4/10/2024, 11:17:45 AM

Applies to

  • NetApp StorageGRID
  • Networking
    • SysLog
    • User Datagram Protocol (UDP)

Answer

SysLog, by default, uses User Datagram Protocol (UDP) port 514. Contrary to Transmission Control Protocol (TCP), UDP does not require a handshake from the receiving end. As long as the message was able to be sent out, it will be marked as successful on the sender's side.

Additional Information

N/A

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.