Skip to main content
NetApp Knowledge Base

StorageGRID EC repair stuck after node recovery

  1. Last updated
  2. Save as PDF
Views:
127
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

NetApp StorageGRID

Issue

After recovering a Storage Node from a failure, the EC repair command gets stuck at 99%:
 
Example:
# repair-data show-ec-repair-status
              Repair ID   Affected Nodes / Volumes                   Start Time                     End Time     State   Estimated Bytes Affected    Bytes Repaired   Percentage   Retry Repair
=================================================================================================================================================================================================================
   17136316949006164375                      <nodename>   2022-10-26T22:50:52.821386   2022-11-24T01:43:10.576763   Failure            435363303900826   435339617803713           99            Yes
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.