Skip to main content
NetApp Knowledge Base

How to configure NLB and ARR with SnapCenter?

  1. Last updated
  2. Save as PDF
Views:
2,193
Visibility:
Public
Votes:
3
Category:
snapcenter
Specialty:
snapx
Last Updated:

Applies to

SnapCenter Server

Description

This article describes how to configure Network Load Balancing (NLB) and Application Request Routing (ARR) with SnapCenter.

  • SnapCenter 4.1.1 or earlier supported configuring of NLB and ARR while installing SnapCenter. However, from SnapCenter 4.2, you should manually configure NLB and ARR outside of SnapCenter installation for high availability (HA).
  • SnapCenter supports only 2-nodes NLB configuration.

Note: If you already installed SnapCenter Server and plug-in, you cannot configure NLB and ARR manually. Perform a fresh installation of SnapCenter 4.2 and then manually configure NLB and ARR.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.