Applies to SF9605 Issue When booting up a node, boot stops with UEFI0067 error code: UEFI0067: A PCIe link training failure is observed in PCIe Slot 3 and the link is disabled. Check Additional Inform...Applies to SF9605 Issue When booting up a node, boot stops with UEFI0067 error code: UEFI0067: A PCIe link training failure is observed in PCIe Slot 3 and the link is disabled. Check Additional Information section for full screenshot
This workflow helps you troubleshoot issues across various third-party software such as Solaris, AIX, HP-UX, Linux and VMware. Host connectivity issues.
NetApp Deployment Engine (NDE) NDE fails at the overall progress of 46 percent and at 91 percent of the section "Set Up ESXi" Timeout for DeployEsxWorker task observed at the sf-nde.info log file (Can...NetApp Deployment Engine (NDE) NDE fails at the overall progress of 46 percent and at 91 percent of the section "Set Up ESXi" Timeout for DeployEsxWorker task observed at the sf-nde.info log file (Can be downloaded from https://storage_MIP_used_for_NDE:442...en_US/nde/logs) File "sfprime/tasks/task.py", line 502, in start File "sfprime/util/fabrixtools.py", line 1634, in wrapper Example screenshots of the failure can be seen at the Additional Information section.
The following is reported in the Active IQ Error Log or Element UI Alerts: The SolidFire Application cannot communicate with node ID X. After attempting to reboot/power cycle the node, it does not boo...The following is reported in the Active IQ Error Log or Element UI Alerts: The SolidFire Application cannot communicate with node ID X. After attempting to reboot/power cycle the node, it does not boot to Element and the following errors are observed during POST: No boot device available or Operating System detected. Current boot mode is set to BIOS Please ensure compatible bootable media is available. Use the system setup program to change the boot mode as needed.
Updating BIOS firmware fails with "Failed to save Primary Image to Backup flash device"; Upgrading from the LOADER prompts "Failed to save Primary Image to Backup flash device"
Applies to AFF/FAS Systems Controller reboots back to 'Loader' Prompt when "boot_ontap" is performed and below errors are displayed: Tue Jun 9 08:41:59 2020 [nv2flash.misc.dbg:NOTICE]: Failed to resto...Applies to AFF/FAS Systems Controller reboots back to 'Loader' Prompt when "boot_ontap" is performed and below errors are displayed: Tue Jun 9 08:41:59 2020 [nv2flash.misc.dbg:NOTICE]: Failed to restore restage key, ret 0x69 Tue Jun 9 08:41:59 2020 [nvram.decryption.key.unavail:FAULT]:Cannot retrieve the keys for NVRAM/NVMEM to decrypt data from the flash device. To prevent NVRAM/NVMEM data loss, halt the system. System is going to shutdown because failed to restage(copy flash to nvmem).
Applies to Brocade G610 Brocade G620 Brocade G630 Brocade fabric switch does not boot to Fabric OS Connecting using a serial console cable, and power-cycling the switch error message After updating SS...Applies to Brocade G610 Brocade G620 Brocade G630 Brocade fabric switch does not boot to Fabric OS Connecting using a serial console cable, and power-cycling the switch error message After updating SSH certificate switch does not boot Failed to mount Ext2 filesystem hda: task_in_intr: error=0x44 { DriveStatusError UncorrectableError }, LBAsect=473188, sector=473188 A fatal CF card failure has been detected. Please contact your service provider for CF card replacement. BUS error, core dumped
