Skip to main content
NetApp Knowledge Base

SnapCreator command line fails to run post upgrade

  1. Last updated
    May 30, 2022
  2. Save as PDF
Views:
212
Visibility:
Public
Votes:
0
Category:
snap-creator-framework
Specialty:
legacy
Last Updated:
5/30/2022, 11:22:22 AM

Applies to

SnapCreator Framework 4.3.3P2 and below for AIX/UNIX

 

Issue

While attempting to run the backup using the command post-upgrade of the SnapCreator from 4.3.3P2 or below to 4.3.3P3 or above, the following error will be seen:

[user@servername ~]$ /opt/NetApp/SnapCreator/scServer/snapcreator --server localhost --port 8443 --user stgadm --passwd <blah blah> --profile tlpstepdb07vth --config FilesystemVGs_01 --action backup --policy Daily1925_35Days --verbose
500 Can't locate object method "new" via package "LWP::Protocol:: https::Socket" at SnapCreator/Service/Engine.pm line 159.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.