Skip to main content
NetApp Knowledge Base

Unable to run 7MTT after the installation

  1. Last updated
  2. Save as PDF
Views:
405
Visibility:
Public
Votes:
0
Category:
7-mode-transition-tool
Specialty:
7dot
Last Updated:

​ ​

Applies to

7-Mode Transition Tool (7MTT) v2.0 or later

Issue

The following error message pops up from a browser after launching 7MTT tool after installation:

Page cannot be displayed

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.