Skip to main content
NetApp Knowledge Base

Ha pair does not synchronize with timeserver in Data ONTAP 7

  1. Last updated
    May 8, 2020
  2. Save as PDF
Views:
277
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:
5/8/2020, 2:12:52 PM

Applies to

Data ONTAP 7 and earlier

Issue

After setting max_skew to 1 second, partners are over 1 minute off.

Time skewed among clustered filers and time server.

Error message: TimeDaemon: source [3.1.6.27]: actual [a negative number, e.g. -87.291] seconds, tolerance [default or preset number, e.g. 0.010] seconds, adjusting time.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.