Skip to main content
NetApp Knowledge Base

Can I manually fail a disk that is not responding?

  1. Last updated
  2. Save as PDF
Views:
1,911
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP 8.2.5 and earlier
  • Data ONTAP operating in 7-Mode

Answer

  • No, spare or broken disks cannot be failed. The disk fail command only works with data/parity disks.
  • Replace the disk that is not responding.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device