Skip to main content
NetApp Knowledge Base

How to configure the LAN interface on a Brocade switch

  1. Last updated
  2. Save as PDF
Views:
644
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
core
Last Updated:

Applies to

 Brocade switch

Description

This article describes the following procedures:

  • How to  configure the LAN interface in the command line on a Brocade switch   
  • To change the IP address 
  • Negotiation of the speed

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.