Skip to main content
NetApp Knowledge Base

Disk RPM and Type are not correct after replacement

  1. Last updated
  2. Save as PDF
Views:
836
Visibility:
Public
Votes:
0
Category:
disk-drives
Specialty:
hw
Last Updated:

Applies to

ONTAP 9

Issue

  • Disk RPM and Type do not display correctly after replacement in SYSCONFIG -R:

RAID Disk    Device      HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
---------    ------      ------------- ---- ---- ---- ----- --------------    --------------
Spare disks for block checksum
spare        1c.02.23    1c    2   23  SA:A   0  FSAS  7200 3807816/7798408704 3815447/7814037168 
spare       1c.01.21    1c    1   21  SA:A   0   SAS 15000 3807816/7798408704 3815447/7814037168

  • If no other spares are available, ONTAP triggers SPARES LOW warning.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.